ZYT15 LCD 1NO1NC Time Controller

ZYT15 Controller Function and Application This product can automatically switch on and switch off the power supply of various kinds of electric equipment, according to customer’s fixed time. It is widely used in programmable control of electric cooker, booster, lamp, water heater, sprayer, bottler, preheater, agriculture facilities and broadcasting equipment etc. Technical Specifications Rated voltage: 220V/50Hz Voltage scope: 85% 110% Capacitance Load: 16A Program: 16 ON / 16 OFF Consumed power<5VA Timing error <±2s/day(25°C±1°C) Timing Control Range:1min 168h Installation: guide rail Temperature:-10°C +60°C Relative Humidity: <95% Dimension:36×86×65mm Weight:120g Operation instructions First time use this timer switch, please input power supply and let battery recharge. 1. Adjust Clock l Before using, please check the clock display to follow the current time, and calibrate it. l Hold down the "CLOCK" key, meanwhile adjust respectively the key “HOUR”, “MINUTE” and “DAY” in accord with the current time. 2. Time setting stepkeySetting content1Press the key "P" The first switch-on setting(display 1ON ) 2Press the key "H+" and "M+" Setting switch-on time (hour, minute) 3Press the key “D+" Working Mode: set the switch-on working days 4Press the key "P" again The first switch-off setting(display 1OFF) 5Press the key "H+" and "M+" again Setting switch-off time (hour, minute) 6Press the key "“D+"" again set the switch-off working days 7Repeat step1 to 6 Set other 2ON and 2OFF, 3ON and 3OFF until 16ON and16OFF(if no, pls make it display “— — : ­— —” ) 8Press the key " " End the setting and enter to the state of clock display. 9Press the key " MANUAL" Adjust on-off sign to the current state "ON" or "OFF" and adjust to the position of "AUTO". Notice: When make an error or cancel the settings, press "C/R "key to make it display “— — : ­— —” ( it means no timing program, not "00:00"). If you set the switch-on time, you must set the switch-off time to correspond. 3. For example Some electrical equipment needs to switch on 19:00, and switch off 08:00 next day. A. Follow the steps 1, 2, 3, and make it display as Figure 1a; B. Follow the steps 4,5,6 and make it display as Figure 1b; C. Follow the step 7, and make each group 2ON and 2OFF, 3ON and 3OFF until 16ON and 16OFF display as“— —:— —”. D. Follow the steps 8, 9 and adjust the work mode to the state of "AUTO".