YLW-8200kw coal fired thermal oil heater

Why choose SHENGWEI? 1-We are a Chinese specialized supplier of thermal oil/fluid heaters. We have been engaged in this field for 18 years, we can design the individual scheme for you in accordance with your fuel and special requirements, our product have a capacity range from 0.1M Kcal/hr to 20M Kcal/hr.We pay close attention to every detail and we are to make them with the highest quality all over the world.2-We can supply you the most leading thermal oil heaters in China, and the best cost performance all over the world.3-We persist the enterprises concept of innovation and team work, we pay more attention to every detail, after all these years, every small part is composed of our wisdom and everlasting study, we hold more than 50 patents, and have a outstanding performance in the energy-saving and environment protection.We introduced the converter technique into our electric control system firstly.We design and manufacture the first Circulating Fluidized Bed Combustion Thermal Oil Heater all over the world.4-Through constant international cooperation about technique and experience, our manufactures have a leading quality and superior specifications. To optimize your energy solution is our eternal pursuit.Rice husk fired thermal oil heater is a mature branch of our products. We have supplied many of this kind of heaters for several Southeast countries like Malaysia, Thailand etc,The Natural Gas and/or diesel fired heaters are very popular in the Middle East countries, Africa countries, north Europe countries, South Korea and Japan are most important of our overseas market.5-We have a overseas market in Southeast Asia, Middle east, East Asia, Egypt and South American countries like Chile and Peru, more than 50 countries have our thermal fluid heaters, all of them with little fault rate and we earns good remark and many potential clients.Why choose thermal fluid heater?The choice between a steam system or a thermal fluid system is governed by the process requirements. The range or process temperature is a deciding factor. If the systems required temperature is above the freezing point of water (32°F) and below approximately 350°F, the choice is usually steam. However, if the required temperature is below 32°F or above 350°F, thermal fluid may be a better solution.Reliability and rugged long life construction ;Guarantee on both the burner and the boiler ;Efficiency, which can be higher than 92% over the operating range ;Investments and maintenance costs reduced ;Optimised heat balance, associates the high output of the boiler with very low thermal losses on the distribution system which means very high overall plant efficiency ;Very short response time, low inertia ;Optimisation of the thermal coefficient of transfer of the boundary layers ;Low pressure of operation normally no more than total system resistance (10 bar max) for high temperature (350°C) ;Well suited for indirect process heating;Compactness ;Safety of the whole system by the installation of dedicated controls and equipment to suit the process requirements (deaerators, temperature monitors and alarms, deaerator relay...) ;No corrosion, therefore, very long plant life.