YH-853D rework station

YH-853D rework station * Features 1, YH853 is based on market needs and designed a three in one multi-tool equipment, it brings together in one common tool (soldering, hot air guns, mobile phone repair power supply), three functions can be used independently or work together, occupy less area, practical and save energy, and in the performance of products on the market there a single function to further improve. 2, products with double-sided fiberglass circuit board material, patch process. Neatly within the process, the signal flow clear. 3, iron, air guns and dc power supply independent dual-core micro-controller, and the brightest to work independently, even if there are problems along the way will not affect another use . Dual-core CPU designs to avoid the failure rate of the product. 4.Fan airflow capacity, limitless adjustable, iron, air gun temperature, supply voltage through the three-way display terminal LED display constantly updated. 5.Iron, air gun temperature side with Intelligent Fuzzy PID control, temperature steady-state error is small, fast temperature compensation, can adapt to harsh environment 6.Air gun, soldering iron with a variety of fault protection 7. DC Power Supply part of the recovery with continuous protection and RF protection, to avoid the interference of all kinds of unexpected phenomena burning mobile phone 8.Products can not only maintain power as a mobile phone, mobile phones can also be detected RF signal strength, led by the RF signal strength indicator shows 9.Product is simple, but for operation without any key to complete. Rated voltage: AC 220V±10% 50HZ ( 110V±10% 50HZ) Total Power: 700W+50W+15W=765W±10%(max) Work environment: 0-50°C Storage temperature: -20-80°C Iron parts Gun parts Dc power supply parts work Voltage :AC:26V±10% 50HZ work Voltage: AC:220V±10% 50HZ\( 110V±10% 50HZ) work Voltage:AC 20V±10% 50HZ\ ( 110V±10% 50HZ) Output power:50W±10% Output power:700W±10% Output power:15W/30W/45W Temperature range:200°C-480°C Temperature range:100°C-480°C Output voltage:0-15V Temperature stability:±2°C Temperature stability:±2°C Load stability:<0.01±2mvTip of ground impedance<2ohm recovery time:<100us Tip of ground voltage<2mV Ripple dB<1mvrms (virtual value) Temperature coefficient:<300PPm/°C Protection starting current:>standard value 10% Instructions This product is extremely simple operation, without all the complicated but can be easily completed for key Iron, air gun part of the operation: 1.click the "∨" , iron, or air gun temperature 1 °C, hold down the "∧" pressed, set the temperature rise in a row, until the time of release button when the required temperature are ok. 2, click the "∨" , iron, or air gun temperature decreases 1 °C, hold down the "∧" pressed, set the temperature of the drop, until the required temperature value you can release it 3.set the temperature to be completed, the terminal continues to display the set value led 2s minutes later, and then show constant temperature DC power supply operation 1) the wave hit the switch output, adjust pressure regulator knob to the required voltage. 2)Adjustment “VOLAGE” knob to the required output voltage, that is the left side of the two terminal output voltage you need. 3)DIP switch to the "output LED", the figures show that the output voltage value 4)DIP switch assigned to "voltage measurement LED", the figures for the first table shows the voltage you measured value, was measured from the right side of the two terminal voltage (TEST) input. 6)Cell phone radio frequency signal measurement: state of the phone at launch, the instrument panel of the RF indicator flashes, RF intensity of reference the following table: 7)Ammeter display range for 0-100mA.