Wire On Tube Condenser for Refrigerator

Wire On Tube Condenser for Refrigerator; Condenser for Fridge; Wire On Tube Condenser for Fridge; Refrigerator Condenser; Raw Material1)Rolling welded steel tube : OutDiameter 4.76mm-6.35mm , Wall Thickness 0.6-0.7mm;2)Low carbon steel wire O.D.1.4-1.5mm ;3)Bracket:Steel Plate (SPCC),thickness 0.6-1.5mm;4)Steel Plate:SPCC with thickness 0.3-0.4mm;Structure1)Flat Type of wire on tube condenser used at the back ;2)Bended or Spiral type of wire on tube condenser used at the bottom;3)Wrapped type of tube embed on plate;Key ProcessTube bending, Tube welding, Fix the bracket, Weld the suction tube, Leakage Test, Coating,Folding or bending, Shaping, Inspection, PackageTechnical Ability1)Wire Pitch ≥5mm;2)Produce according to the drawing or sample supplied by clients;Performance1)Surface with electrophoresis coating to prevent the corrosion2)Inner cleanness can meet the requirement of R134a &CFC cooling system;3)Can satisfy the cooling capability requirements;4)Producing Capacity: 5000 Set/Day;R134a Cooling System Tube Inside StandardsResidual Moisture≤20 mg/m2Residual Impurity≤30 mg/m2Residual Mineral Oil≤7 mg/m2Residual Chlorine≤0.3 mg/m2Residual Paraffin≤0.2 mg/m2Specification of CoatingCoating ThicknessThickness of cathodic electrophoresis coating ≥12 umHarness of Coating≥2HImpact of Coating50 cmkg/cm impact, no crackAdhesion of coating≥ two gradeFlexbility of CoatingAround R=3D bend 180°,no crack or no fall offColor tolerance of Power PaintingE ≤ 1.5Corrosion Resistant (Salt Spray GB2423)Cathodic electrophoresis ≥ 96H