VKR watchband contact finger

Watchband spring produced by our company is made of imported and domestic high-performance excellent conductive material through special technology. It applies to switchgear compact electrical contact structural design. It depends on elastic deformation of each contact unit so as to provide contact pressure, so as to manufacture single-point contact, dual-point contact or inlaying contact of stronger flow according to contact properties for loading of rated current, dynamic-thermal stability current.. It is extensively used in intermediate main conducting loop sliding contact and GIS bus connection static contact. Characteristics: Small dimension, simple structure, many contact points, strong flow capacity, high reliability, no compression spring needed, stable contact pressure, fatigue resistance, convenient installation, long service cycle, wear resistance and conductor not subject to scratching. Our companys VKR watchband contact finger series products amount to over 30 specifications and varieties so as to satisfy various requirements of extensive customers with machining according to buyers drawings and samples. Besides, research and development department would offer specialized design and development service to you. Grooves of corresponding dimensions are just required for using spring contact finger and watchband contact finger with very convenient installation; clack contact finger (tulip contact finger) shall be equipped with clamping spring, clamp ring, shielding case and etc., not only large in dimension, but also complex structurally.