Turbine lube oil purifier

The Vacuum Dehydrator oil purifier's principal function is the removal of water, gases, and light hydrocarbons from oil. The system is operated under vacuum conditions, and the oil is forced by atmospheric pressure through a heating chamber engineered to raise the oil temperature to a desired level. The flow through the elements is inside out, with the elements also action as filters to remove solids.Next, the oil is exposed to a vacuum where water(free, dissolved, and emulsified), dissolved gases, air, and other low range volatiles are boiled off by a heat/vacuum process, with this process, the oil is purified and conditioned to a safe operational standard. The gases are pulled off by a water ejector or vacuum pump and pass through a cooling device for condensing.the condensing steam and vaporized contaminants are then ejected automatically as waste. No additives or detergents are removed. These units dehydrate oil, through th proper application of heat and vacuum while circulation to and from a single reservoir at a specific rate of flow.The units are not sized to purify oil in a single pass. Purity and temperature rise with each pass.The maximum heat rise per pass is 50F. Th suggested number of passes is normally four(4) . A minimum of 140F oil temperature is required to purify most oils(not to wxceed 185F) Thus, the customers reservoir size ,the ambient temperature of the oil and the amount of contaminants will determine the mumber of qreuired passes to purify the oil. Features: 1)Removes up to 1% water in a single pass. 2)Removes down to 0.5microns in filtration 3)Flow pattern does not agitate th oil 4)Unit is modular 5)Electrical:explosion/weather-proof enclosures. 6)Automatic controls designed for unattended operation 7)Heater controls are solid state