tungsten carbide cutting tips

tungsten carbide tipsare replaceable cutting tips and designed for nonstop cutting cast iron, alloy and other nonmetal materials in precision lathe. These inserts with excellent properties are also for interrupted cutting, whirling of rough turn in semi-precision lathes, precision lathes or small-section precision lathes. Our Carbide inserts are wear resistant.GradeDensity g/cm3 TRS N/mm2Hardness(HRA) Application recommendedYF10.114.80—15.15 ≥1880≥91.0Suitable for drawing dies to draw small diameter ferrous wire and non-ferrous metal wire a high speed YF10.214.30—14.65 ≥2430≥91.8Suitable for strips to make wood-working tools YL8013.75—14.05 ≥3200≥89.5Suitable for plates to make die blanks YL80.114.70—14.90 ≥2020≥89.5High abrasion resistance, used in powder metallurgy mould etc. YL80.214.00—14.20 ≥2900≥86.5Suitable for making small watch parts, punching dies of instrument, roll, cut the trigger. YL80.313.50—13.80 ≥2540≥85.0Suitable for producing punching plate under high stress. YL9013.50—13.70 ≥2500≥82.5With high strength and toughness, suitable for making large size reducing die, better than YG20C. YL90.113.90—14.10 ≥2340≥84.5Suitable for die blanks for reducing diameter with large dimension and dies blanks assembled of six pieces YL90.213.70—13.90 ≥2400≥83.0Suitable for die blanks for reducing diameter with middle dimension YL90.413.20—13.40 ≥2600≥82.0High strength and toughness, used to cold heading mould, cold impacting mould and cold press mould with high pressing YL90.513.00—13.20 ≥2760≥81.0Good impact resistance, fatigue resistan,used for high loading punching die YL90L13.20—13.40 ≥2550≥81.5Used for general cold screw scissors die and cutting shear blade tips YG6A14.80—15.10 ≥1580≥91.5Suitable for semi-finishing of cast, nonferrous metal and low-alloy steel YG6X14.70—15.10 ≥1600≥91.0Suitable for drawing dies to draw steel wire, on-ferrous wire and rods with small diameter at a high speed YG614.70—15.05 ≥1670≥89.5Suitable for drawing dies to draw steel wire, on-ferrous wire under a diameter of 20mm and tubes under a diameter of 10mm YG814.60—14.8 ≥1840≥89Suitable for drawing dies to draw steel wire, on-ferrous wire and alloy rods, tubes, also for making wear parts, tools(such as muzzles, grinders, drills ect.) YG1513.90—14.20 ≥2700≥86.5Suitable for drawing dies to draw steel rods and tubes at a high compression ratio, also for heading dies, drills etc. YG2013.40—13.70 ≥2480≥84.5Suitable for punching and heading dies