Specification for Spray Booth JNT-103NameSpecificationOptional1.BodyPanelSandwich Style,δ=50MM,polystyrenerock woolBasementSteel structure,3 rows of vein board & 2 rows of gridsfull gridsRamp2 pcs of vein boardEmergency door1 pc of emergency door with pressure lockFront door3 pcs of front door without aluminum side cover2.Air SystemFrameSteel,powder coatedIntake fan2 units of 4kw certrifugal fanExhaust fanno11kwIntake ductNoIntake ductExhaust duct4M straight exhaust ducts,one 90°bend,and one 60°bendChimney duct4m straight chimney and 2 small bendsSpraying/baking Transition damperAutomatically air controlledBurnerBairui/BT14RIELLO/G20Heat exchangerStainless steel,circular heating,chimney at front.3.Filtration SystemRoof Filter4pcs of filter,mounted above support frame, which is made of steel and powder coated.Floor filter2pcsAir mouth filter1pc4.Light SystemUpper light8sets,3*40W per setSide lightNO5.Electric SystemControl panelcomponents made in China,overload,overheat,phase-lacking protection,motor direct start.Pressure meterNoAutomatically stopAutomatically stop when preset time is up.Constant temperature sprayingYesPower10kw6.Environmental SystemEnvironmentalNoM style activated Carbon or drawer style activated carbon Attention:optional parts are not free. Technical Parameter: Extenal size(M)Internal size(M)Door width(M)Door height(M)Air flow(m3/h)Inside on-load air speed(m/s)Power(kw)Vehicle suited7.0*5.5*3.46.9*3.9*2.732.66220000.25-0.3510saloonbus painting booth