Split solar water heater(CHCH)

Solar/ Solar water heater/ Split high pressure solar water heater 1. The collector and the water tank are separated, and the system runs under the forced pressure. 2. The controlling device is specialized, so the system runs automatically. 3. The water tank can be installed anywhere. 4. The heat pipe vacuum tube collector is two-circuit system, free of freezing and could be used all year. 5. The metal super - conducting vacuum heat collector is used, no water in the tube, no bursting and could be used as usual under minus 50°C. 6. The water tank applies with the enamel internal bladder, runs under pressure. 7. Provide the water at the same temperature, set the highest temperature, and heat the water at set point by electricity, protecting the data when power off, supply the hot water 24 hours a day. 8. The system is designed separately, in harmony with the structure. 9. The heat collector could be mounted on the balcony veranda, the southern wall, sloping roof or awning. 10. The system is designed as unit, convenient to transport. Solar collector: Material: borosilicate glass according to ISO3585:1991; transmittance of borosilicate glass: 0.92. Absorbance of solar selective absorptive coating: 0.94; Hemispherical emittance: 0.08; Getter according to GB/T9505-1998. Start-up temperature: no more than 25°C. Start-up time: no longer than 2 minutes under normal sunshine. Low temperature resistance: no breaks at-30°C. Heat impact resistance: no damages after over 3 times' alternative impacts of cold water below 25°C and hot water over 90°C. Pressure resistance: can withstand 0.6MPa. Hail resistance: no damage by the impact of Φ25mm hail. Appearance standard: the color of the selective absorptive coatings should be even,and the coatings should have no wrinkles and peelings. The allowed tolerance of borosilicate glad glass tube's diameter should be in accordance with ISO4803:1978. camber of the borosilicate glass tube should be no more than 0.3%. The translation the borosilicate glass tube, which is 40-60mm away from flange end, should be round. The ratio of the longest to the shortest radial dimensions of the borosilicate glass tube should be no more than 1.02. Manifold material: SUS304 2B stainless steel or aluminum alloy. Water tank: without copper coil, with 1 copper coil and with 2 copper coils. Inner tank: macromolecular or enamel material. Outer tank: stainless steel. Heat preservation: rock wool or 55mm imported PU. Temperature sensor. Electrical heater. P/T valve.Vent valve.Working station: Expansion case (made in Italy) Check valve Circulation pump (made in Germany) Intelligent controller Pressure guage Safety valve: stable working pressure at 0.6MPa ensures the system working stabilization