Sell ground enamel by rust 3 in 1 in Vologda

Description The ground-enamel 3-in-1 XB-0278 is a suspension of pigments and fillers in a solution of perchlorovinyl, epoxy and alkyd resins in organic solvents with the introduction of a modifier rust and combines the properties of rust Converter, primer and enamel. XB-0278 does not require special preparation of the metal before painting. Scope Primer-enamel HV-0278 designed for corrosion protection of new and old metal surfaces, the cleaning of which is difficult. XB-0278 can be applied to tightly hold the rust layer up to 50 µm). The material can be used in the manufacture of new and repair of old structures, and in particular: in the repair of automobiles (for painting rusted surfaces, bottoms, wings, sills, and other items), when painting Parking garages, roofs, wrought iron grilles, etc. Anticorrosive primer-enamel HV-0278 is used as protection of metal structures exposed to atmosphere, the complex coating with enamels and lacquers type HS, HV, ML, PF for protection from exposure to salts, corrosive gases, etc. at temperatures not exceeding 60°C. the Primer-enamel is a composition of 3 in 1 (three in one), and it combines the properties of rust Converter, primer and enamel. Cover the surface 100% covered with scale and fitting tight with rust, which consists of three layers of priming enamel, in temperate and cold climates and retains its protective properties during 4 years. Surface preparation: before painting the steel surface is cleaned of old loose coating, loose rust and scale. Dirt, oil, then remove dust and degrease with solvent R-4 or R-4A. Methods of application: by brush, roller, airless spray or dipping processes dilution is not required. In pneumatic spraying of diluted R-4 or R-4A. When painting metal surfaces, covered tightly holding the rust, to improve adhesion it is recommended that the first (dark) layer is applied of a thickness more than 10-15 microns. The thickness of the subsequent layer 28-32 microns. The total thickness of 70-80 microns. As coating materials it is possible to use any enamel, except for the nitro and epoxy.