pulp pump

1, SZP-type centrifugal pumps for the pulp and a single-stage single-suction cantilever structure after the door, do not disassemble pipeline maintenance, import and export pump flange design by 1.6MPa pressure. The main parts from the pump casing, the former protection lining, impeller, after the protection lining, after the pump cover, the middle frame, suspension, shaft, bearing cap before and after. 2, SZP-type centrifugal pulp pump is our engineering and technical personnel for the paper, pulp, sugar, starch, Recovery Enterprise design pumps. The series of pump impeller for the semi-open, non-blocking, sealing position without leakage, wide flow channel, through the ability, through the diameter 20-80mm, fiber length 100-250mm, transport slurry concentration range of below 6% slurry, the pumps and apply a certain amount of liquid gases. Wide range of applications than the existing market products to improve the efficiency of 8-15% or so. 3, before the protection gap between the liner and the impeller pump can be adjusted on the adjustment bolt, the impeller can protect the liner with a constant gap, thereby enhancing the efficiency of the pump. 4, sealing can use a single mechanical seal, packing two sealed form, the user can request and use. 5, pump manufacturing material for cast iron, cast steel, ordinary stainless steel, duplex stainless steel of four, bearings Harbin Bearing Factory quality bearings. 6, pump impeller balancing check to ensure that the work balance impeller run. 7, pump motors are used on the national exemption product, Anhui JAC Electric Co., Ltd.. 8, pump over-current used in all parts of polishing to ensure the quality of pulp from the overall look nice.