pulp pump

1, SGZ-based non-blocking paper pulp pump leak-free after the door structure, maintenance, do not disassemble pipeline, import and export pump flange design by 1.6MPa pressure. The main parts from the pump casing, the former protection lining, impeller (three-blade or six leaves), after the protection lining, after the protection lining, after the pump cover, suspension, shaft, bearing cap before and after. 2, our company imported pulp pump based on the improvement of the hydraulic model, increasing the pump capacity and the concentration of slurry delivery. The series of pump impeller is fully open and with no plug, sealing position without leakage, wide flow channel, through the ability, through the particle diameter of 20-80mm, fiber length 100-400mm, transport slurry concentration range of below 6% size, for a wide range of products than the old pump about 10-20% efficient. 3, sealing can be used, single mechanical seal, packing two sealed form, the user can request and use. 4, pump manufacturing material for cast iron, cast steel, ordinary stainless steel, duplex stainless steel of four, bearings Harbin Bearing Factory quality bearings. 5, pump impeller balancing check to ensure that the work balance impeller run. 6, pump motors are used on the national exemption product, Anhui JAC Electric Co., Ltd.. 7, pump over-current used in all parts of polishing to ensure the quality of pulp from the overall look nice.