New Ceiling 360 degree Remote Control PIR Motion A

Description:1.This independent alarm is a wireless infrared reaction product.2.There have remote controllers. There are four buttons on the controller.arm,disarm,emergency button,arm again.3.The device doesn’t detect the altering signals in 20seconds,after automatic defense-deploying is initiated, so please leave the detected area within this period.4.The device will give alarm for 30 seconds once it detects anybody entering the detected area. After the alarm stops ringing for 5 seconds, the infrared detector will automatically reset and go into detection again5.When the infrared detector (electronic dog) is alarming, the sound can be stopped by pressing the button of “withdrawal” on the remote control. Defense redeployment can be set by pressing the buttons of “Defense-deploy 1” and “Defense-deploy 2” on the remote control. If you want the alarm sounds in the state of withdrawal, you can press the button of “Emergency” on the remote control and the alarm will sound nonstop. If the button of “withdraw” is pressed, then the alarm will be stopped. 6. Warning devices as remote control infrared lens in the human lateral movement relative to the infrared detection highest sensitivity,please care this when you install.7.The infrared detector (electronic dog) can be powered by both direct-current power supply or four AAA chargeable batteries in case of unexpected power-off.8.As a result of a dual infrared sensors with special infrared integrated circuit,with accurate reporting,high reliability,high cost performance characteristics,suitable for home,office,garden,street stores and other places need anti-theft alarm.Technical Parameters: Operating Voltage:AC110V-220V(6pieces,AAAbattery) Standby current: ≤6uA Alarm current ≤100mA Detection range:7-12meters InfraredAngle:120°(RL) Alarm sound level:≥110dB Usage: 1.Turn on the power switch, turn indicator light about that white check normal. 2.Infrared remote control device in the just-warning aircraft standby after 20 seconds delay, within 20 seconds alarm signal is not detected, you must leave within 20 seconds in the detection area of electronic dog. 3.20 seconds after the warning if there is to gain access to infrared detection device area, infrared remote control device will have 30 seconds warning after that delay, so the owner to facilitate the identification, 30 seconds, alarm volume more than 110dB. after the alarm sounds, if there are warning staff contact infrared remote control device, it will alarm again, again and again. 4.Infrared remote control device in the alarm warning, you can turn off the power switch the remote control to end the alarm. Packing:1set/Box size:10*6*14cm(L*W*H) 46set/Carton