Natural Gas/Fuel Oil/Coal/Biomass fuels Fired ther

Why choose thermal fluid heater?The choice between a steam system or a thermal fluid system is governed by the process requirements. The range or process temperature is a deciding factor. If the systems required temperature is above the freezing point of water (32°F) and below approximately 350°F, the choice is usually steam. However, if the required temperature is below 32°F or above 350°F, thermal fluid may be a better solution.Reliability and rugged long life construction ;Guarantee on both the burner and the boiler ;Efficiency, which can be higher than 92% over the operating range ;Investments and maintenance costs reduced ;Optimised heat balance, associates the high output of the boiler with very low thermal losses on the distribution system which means very high overall plant efficiency ;Very short response time, low inertia ;Optimisation of the thermal coefficient of transfer of the boundary layers ;Low pressure of operation normally no more than total system resistance (10 bar max) for high temperature (350°C) ;Well suited for indirect process heating;Compactness ;Safety of the whole system by the installation of dedicated controls and equipment to suit the process requirements (deaerators, temperature monitors and alarms, deaerator relay...) ;No corrosion, therefore, very long plant life.