Most-Advanced MY Stone Crusher

MY crusher is a single machine and also a new type of ore crushing device with high input, high crushing ratio, high output and low energy consumption which can crush three sections. It is reasonably designed and elaborately manufactured, belongs to the advanced crushing machine in the world. Low speed, big torque, axial symmetry equilibrium design: MYcrusher provides less than 2M/S impact velocity of movable teeth, effectively solves worn grinding material and gouging abrasion caused by vibration, noise and high speed, prevents rock ore from “impedance” due to high speed. An upright main shaft linkage for cutting and rolling: Main shaft linkage of PFH ultrafine crusher is adopted a driving component system to conduct cutting from top to exert big rock ore with impact, bending and point pressure in the controlled condition, also conducts rolling from bottom, applies the fine granular ore at a rolling force in the laminating condition, so fulfills forcing as different categories, conforms to mechanical characteristics of rock ore, saves labor and energy. Large area design: The cutting device of PFH ultrafine crusher, besides the blanking opening at lower circumferences of inner cone and outer cone, the blanking hole among teeth of inner cone and outer cone enlarges the blanking area; granular rock ore from rolling section is crushed down by roller and forced to fall from long holes of roller base, whole unit discharges smoothly. Less investment, lower energy consumption, lower running cost, how can this machine accomplish the processing of “three-section one closed circuit”? Maybe you can link bionics and “digestive system” for a better understanding. Crushing ore is a “digestive system”, cutting from top means “chewing”, the different teeth crush the hard material, then fall into lower “intestines and stomach” for rolling, then discharge. Animal shall not separately finish digestion, we can finish with only one machine. PFH ultrafine crusher designed in line with aforesaid concept has such advantages as follows: 1. Little space, low civil engineering cost; 2. Less steel consumption, low energy consumption; 3. High capacity, less total investment; 4. The wearing parts have long service life, achieve low running cost; 5. Small vibration, less dust, simple to design movable station; MYseries (double tooth) crusher is a type of new machine by adopting impact forcing mode and full-course controlled crushing in accordance with theory of low speed and axle symmetry. MYseries (double tooth) crusher has low speed and big torque to ensure stronger impact energy of movable teeth, so lightly crush big materials and avoid worn grinding and gouging peeling caused by high speed, prevents rock ore from impedance due to forcing at high speed. Lower grinding loss, higher crushing ratio. MYseries (double tooth) crusher holds axial symmetry equilibrium design to perfectly settle the problems of vibration and noise. It requires lower civil construction cost, achieves lower cost. MYseries (double tooth) crusher meets with rock ore properties of maximum compressive strength and lower bending strength, thus easy to crush and save more energy as well as achieve lower running cost. MYseries (double tooth) crusher owns larger blanking area and can timely discharge standard granular block mass, achieves high output, more regular granular shape and less powder.