Mitsubishi MUT3

Mitsubishi MUT3 Basic Functions: • The MUT3 can be utilized for all types of vehicle electronic control units (incorporating the diagnostics function). • The MUT3 reads each diagnostic code and displays it as a name. • Using serial communications, the MUT-III reads the RAM data (data list) within the ECU that is required for servicing, thus enabling the display of both graphs and numeric values converted to physical quantities. (Only for ECUs that support serial communications.) • The MUT3 can forcibly drive or forcibly stop the actuators required for servicing. (Only for ECUs that support serial communications.) • Using its voltage measuring function, the MUT-III can measure DC voltage ranging from +/-40V. • Using its resistance measuring function, the MUT-III can measure resistance ranging from 0 100kOhm. V.C.I. Function Fault Diagnosis: •The V.C.I. can perform fault diagnosis by receiving commands from a PC and communicating with a vehicle ECU. The buttons on the V.C.I. will not function while it is connected to a PC. [Start-up Screen] •The screen to the left will be displayed when the USB cable is connected to the main unit. The direction of signal flow between the PC and the V.C.I. will be indicated by an arrow, such as [P->V] or [P<-V]. MUT3 PC software application supports following languages: English, Czech, French, German, Greek, Italian, Spanish, Turkish, and Russian. Set Includes: (1) Vehicle Communication Interface (V.C.I.) (MB991824) A communication interface used to connect the vehicle ECUs and the PC. 1. When connected with the PC - Vehicle diagnosis (Interactive fault diagnosis) - SWS communication; CAN communication support - Drive recorder - Volt, Ohm, measurement - Fuel pressure measurement (Not available in US) 2. When used with the V.C.I. unit (disconnected from PC) - V.C.I. Stand-alone diagnosis - Drive recorder - ECU reprogramming - Volt, Ohm measurement - Belt Tension measurement (2) Memory Card Stores data for ECU reprogramming, drive recorder, etc. This is a standard, off-the-shelf memory card. The one provided (with reprogramming data) is a Compact Flash memory card (MB991853) inserted into the CF card adapter (MB991939). (3) MUT3 Main Harness A (MB991910) Used when connecting the V.C.I. with vehicles that have only one 16-pin diagnosis connector. - Supports fault diagnosis and ECU updating on the above-described vehicles - Supports the CAN communication system (4) MUT3 Main Harness B (MB991911) Used when connecting V.C.I. with vehicles that have a 16-pin + 12-pin or 16-pin + 13-pin diagnosis connector. For models equipped with only 12-pin (or 12-pin + 12-pin) diagnosis connector, connect the M.U.T.-II adapter harness (MB991498) to the end of this harness in the same as M.U.T.-II, and power is supplied from the cigarette lighter socket. (5) Carrying case MUT3 manual SMV manual PLEASE CONTACT US!