KangDa Anaerobic Thread Locking Adhesive

No. 222 Low Strength thread locker Designed for thread <M6 Can be disassembled by normal wrench Can be applied to some inert surface No. 242 Medium Strength thread locker Thixotropic, for normal use Designed for thread M6-M20 Can be disassembled by wrench No. 243 Medium Strength thread locker Good oil resistance, suitable for thread with appreciably oil Designed for thread M6-M20 No. 277 High Strength thread locker High viscosity and good chemical media resistance Designed for thread <M36 Can be disassembled after heating if necessary Good antirust, anti-corrosion performance No. 262 High Strength thread locker Thixotropic and good chemical media resistance Designed for thread <M20 Designed for permanent thread locking No. 271 High Strength thread locker Medium to low viscosity Good chemical media resistance Designed for thread <M36 No. 272 High Strength and Hi-Temp resistance thread locker Hi-Temp resistance up to 230degrees C Cures fast even on uncleaned surface Can be disassembled after heating if necessary No. 290 Penetrate thread locker Low viscosity and fast curing speed Designed for thread M2-M12 Suitable for sealing pinhole of the cast Item No. Color Viscosity (mPas) Average disassembling torque (N.M) Breakaway torque (N.m) Working Temp. (°C) Curing time (initial/full curing at 25°C) Specific Gravity (g/cm3) WD222 Purple 1200/5000, thixotropic 1 – 6 3 – 9 -55 – 150 20min/24h 1.05 WD242 Blue 1200/6000, thixotropic 1.5 – 7 10 – 25 -55 – 150 20min/24h 1.05 WD243 Blue 2250/12000, thixotropic 4 – 10 15 – 25 -55 – 150 20min/24h 1.08 WD262 Red 1800/5000, thixotropic 10 – 35 16 – 38 -55 – 150 20min/24h 1.10 WD271 Red 400/800 20 – 35 18 – 33 -55 – 150 20min/24h 1.11 WD272 Red 4000/15000 20 – 31 16 – 28 -55 – 230 30min/24h 1.10 WD277 Red 6000/8000 23 – 40 23 – 40 -55 – 150 30min/24h 1.12 WD290 Green 9/16 17 – 41 3 – 17 -55 – 150 20min/24h 1.08 User's Guide: a) Clean the surfaces to be bonded with solvent and make the surfaces free of grease b) Product should be applied to fill all engaged threads c) Tighten the thread and wipe off the excrescent adhesive d) After 20 minutes curing, you will have the initial bonding strength and after 24 hours, you can get the full bonding strength.