Epoxy colorful silica floor coating system

Name:SP-04 Epoxy colorful silica floor coating system Category:Floor Coating Detail: SP-04 is a two-pack, seamless, epoxy floor coating system with the following properties: Excellent decorating effect. Mixed color freely. Excellent abrasion resistance. Good corrosion resistance against acids, alkalis resistance. Very high mechanical strength. High level of aesthetics: Application areasSP-04 is mainly suitable for places where, for ergonomic reason, the above properties are required in office, subway, airdrome, multipurpose hall, exhibition hall, apartment, hotel, dining room, rest area, hospital, school, etc. Packing SP-04 Part A: 15kg containers. SP-04 Part B: 15kg containers SP-04 Epoxy colorful silica floor coating system Product description SP-04 is a two-pack, seamless, epoxy floor coating system with the following properties. l Excellent decorating effect. l Mixed color freely. l Excellent abrasion resistance. l Good corrosion resistance against acids, alkalis resistance. l Very high mechanical strength l High level of aesthetics; Application areas SP-04 is specially suitable for places where, for ergonomic reason, the above properties are required in an office, subway, airdrome, multipurpose hall, exhibition hall, apartment, hotel, dining room, rest area, hospital, school, etc. Performance data ITEM INDEX Touch dry ≤6 Drying time,h: Hard dry ≤24 Abrasion esistance(1000g/1000r,weight loss,g) ≤0.03. Compressive strength, Mpa ≥70 Flexible strength, Mpa ≥6. Tensile strength, Mpa ≥7. Bonding strength, Mpa ≥2 Shore D hardness ≥80. Application instructions Surface preparation l The compressive strength of the concrete substrate should not be less than 25N/mm2, the best application temperature is between 10--25.The air humidity must not be higher than 80%, the moisture content of the substrate shall not be higher than 8. l Correct substrate preparation is critical for optimum performance. Surfaces should be sound, clean, dry and free from loose particles, oil, grease, and all other contaminants l Remove oil, grease by scrubbing. Cement laitance, loose particles, pitch and other contaminants must be removed from the surface by sand-blasting. The alkalinity and porosity of the surface must also be considered when painting. l Fill surface cracks with epoxy-reinforced solvent-free repair mortar to achieve a level surface.