Double-Junction Amorphous Silicon Solar Module

For Double-junction A-Si Solar Module, we have adopted two pieces of glass for their encapsulation technology. So that the modules strength and resistance to the extend a lot. New Encapsulation Method: New A-Si solar modules adopt EVA and TPT cover which are produced by famous European enterprise. This method can guarantee the modules quality, and improve the lifetime and reliability different conditions. Its special technology increases the ability of the solar cell to absorb sunshine, and change it into electricity efficiently PRODUCT DESCRIPTION During the first several months of operation, electrical output will exceed the specific ratings. Power output may be higher by 15%, operating voltage may be higher by 6% and operating current may be higher by 9%. Electrical specifications ate based on measurements performed at standard test conditions of 100mW/cm2 irradiance, Air Mass 1.5, and Cell Temperature of 25.Actual performance may vary up to 10% form rated power due to low temperature operation, spectral and other related factors. Maximum system open-circuit voltage should not to exceed 600 VDC. These products are strictly designed and manufactured according to IEC61646 Electrical Characteristic JN-36JN-38JN-40Type 363840Maximum Power (Pmax) (Watts) 444546Voltage at Pmax (Volts) 596061Open Circuit Voltage (Voltage) 1.01.01.0Short Circuit Current (Amps) Tolerance of Wattage ±3%Temperature Coefficients Temperature Coefficients of Isc +0.09%/Temperature Certificates of Voc -0.28%/Temperature Certificates of Pm -0.19%/Dimensions & Weight Length (mm) 1245Width (mm) 635Depth (exclude junction box) (mm) 7Weight (kg) 13.2Temperature Range -40--+85