Digital Automatic Tyre Inflator

Automatic Tyre Inflator E-0124-OPS Main Features: Inflate up to 4 tyres simultaneously at the touch of a button ** Inflate up to 4 tyres simultaneous could save 60% time than single tyre inflation ** 174PSI/12bar/1200kPa Output pressure make the unit a fit for almost any size automotive service facility ** Fully Automated, fully programmable, micro-processor controlled conversion system. Self-diagnostic features. Over Pressure Setting(OPS) Suit for: Car, Light Truck, Bus * Technical Data Summary Dimensions(Height*Width*Depth) 510mm*230mm*120mm 20.1''*9.1''*4.7'' Net Weight 6kg/13.2lbs Gross Weight 14.5kg/32lbs Packing Size(Height*Width*Depth)200mm*580mm*480mm 7.9''*22.8''*18.9'' Power Requirement 100-240Vac 50 / 60HZ Power Consumption23VA Operating Temperature Range -20/-4°F to 70 / 158°F Max Inlet Air/Nitrogen Supply 217PSI / 15bar / 1500kPa Operating Range 5-174PSI/0.3-12bar/35-1200kPa Over Pressure Setting Range 0-29PSI/0-2.0bar/0-200kPa Accuracy ±1PSI/0.07bar/7kPa Resolution 1PSI/0.1bar/5kPa Units of Measurement PSI/bar/kPa Specifications: 1. Adjustable over pressure setting(OPS) 2. 4 air outlets allow simultaneous inflation of up to 4 tires 3. Auto-Start inflation 4. Automatic zero drift adjustment 5. Remain at last setting 6. Comprehensive diagnostics and error reporting 7. Audible and visual end of the cycle signal indicators 8. Large backlight LCD display 9. Vandal resistant mechanical switches 10. Suits Standard nitrogen bottle/Direct nitrogen supply from generator/Air compressor 11. 4 Nos.*10M/32.8ft standard hoses with single clip-on open type chuck 12. 1400mm/55.1 grey mounting steel stand base Supplied separately Detail Description of OPS: Over Pressure Setting(OPS) When fitted,the bead of the new tyre must be seated on the wheel rim.This is done via inflating the tyre past the required pressure until the bead is in place.The pressure needs to then be reduced to the required pressure.Traditionally this is done manually and is therefore time consuming for the operator.The OPS function allows the operator to set the amount of over pressure between 0 and 2 bar/29psi/200kPa.The unit will then over inflate the tyre by the set amount before automatically deflating back to the final pressure required.