Cross Joint

Cross JointOur Factory SpecializeIn Manufacturing Inner C.V.Joint And Half Shaft For Over 8 Years Long ,WeHave Advanced EquiPment AndTechnological .Our Products Pass The International Quality Control ISO9001-2000 .ModelMaterialOuter TeethInner TeethOil SealTOYOTASteel20321.Quality assurance:ISO9001-2000 .2.Productivity Rate:25.000 Pcs per Month3.Delivery: 40 Days by Sea .4.Packge: Plastics bags ,Cartons ,Wooden Case .Features :1) The C. V. Joint was designed to meet rigid tolerances and to fit and replace a wide range of OEM applications 2) Complete C. V. Joint kits include C. V. Joint, boot(rubber), grease, nut and clamps 3) The C. V. Joint boot is used to protect against road hazards, while grease keeps dirt and moisture out, it can work good in ozone or -40 Centigrade temperature or other causticity condition. 4) Quality components and rigorous engineering ensure longer durability. 5)We produce almost all kinds of Inner C. V. Joint for America/Europe/Japan/Korea/Russia and other models cars. 6)Welcome to make orders by your samples.Tripod Inner c.v.jointTj type:tripod joints do not have balls but instead use needle bearing rollers mounted on a three –legged spider .the roolers are mounted at 1 20 degrees to one another and slide back and forth in track in an outer “tulip”housing .tripod style joints are used for the inner joints almost domestic and Asian FWD models from 1983 to present this type of joints os well –suited to the limited operating angels of the inner location. The joint is designed to plunge in and out the same as other inboard joints to allow changes in shaft length as the suspension moves the tripod inner groove roughacst ,so as to ensure a longler life .it is also chemically trested to prevent corrosion and enable easier installation and dismanting .