Best Quality Hose Crimping Machine

Product Technical Parameters: clip pipe dimension:6---51mm mould dimension:17---63mm Rated pressure:31.5Mpa The largest crimping pressure:407T electri motor power:2.2---4kw working voltage:220v&380v outline dimension:length*width*height 850*430*1030mm weight:250kg Operation Based on the size of the rubber hose to be buckled, select suitable mould as per the technical parameter reference table of the locking pipe and mount it on the mould base. Regulated well the scale position as per the data in the data in the table, the pipe locking can be done. After pipe locking, use a vernier caliper to mease the outside diameter dimension of the pipe sleeve after buckling to see if it meets the reference table data of the parameter. If it does not meet the data, the scale shall be precisely regulated until it meets the requirements. Because the manufactures of the pipe sleeve are different, so, specific dimension, material, hardness etc are certainly not the same. These factors would result different influences on the pipe locking result, therefore, the data in the table is only for reference, the detailed data take the pressure test as the basis. Notices 1.When buckling, make the joint to locate the mould center as much as possible, the joint is not buckled on the hex nut. 2.Prevent tool and other foreign matter from entering the locking head. 3.After the work is finished for each time, the eight-block mould base must be made to extend to the greatest extent, this can make the spring to be at extension status. If not, the spring will be damage. 4.When working, the hand should not stretch into the locking head. 5.The power supply must be switched off when maintenance is done.