Anti-fungus Silicone Sealant

ANTI-MILDEW SILICONE SEALANT Characteristics: 1.One component, neutral room temperature curing, oxime type, excellent adhesion property for most building materials. 2.Excellent anti-mildew property, keep good performance under the dark and humid environment. 3.Form superior silicone rubber seal after cured, withstand continuing repeated tensile and compression, keep excellent performance under the temperature of -50oC+100oC. 4.Long use life, withstand snow rainfall, ultraviolet radiation, ozone, etc. Main uses: 1.Anti-mildew, waterproof and installation sealing of various kinds of kitchen appliances, sanitary wares. 2.Filling and sealing of building decoration engineering. 3.Sealing of various of windows or doors glazing. 4.Filling and sealing of glass, marble, aluminum plate,etc. 5.Many other uses. Instruction for use: 1.Make an adhesion and compatibility test between sealant and substrate prior to use. 2.Clean with solvents or suitable detergent to keep substrate completely clean and dry. Use sealant within 30 minutes after cleanness. 3.Ensure filling the joint with enough sealant and intimate contact the substrate surface. Within 5 minutes of application tool the sealant. 4.Suitable application temperature range is 5oC 40oC. Limitation: 1.Not for structural glazing. 2.Not suitable for use underground. 3.Not for permanent or continuous water immersion. 4.Dont use on material that bleed oils, plasticizers or solvents. 5.Not suitable for copper, brass and zinc as discolouration may occur. 6.Do not use in direct contact with silver coating of mirrors. Notices: 1.Ensure adequate ventilation environment. 2.Abide by the relative safety criteria when using solvent. 3.Keep out of reach of children. 4.In case of eye contact, rinse with clean water or seek medical help immediately. Storage and transportation: Keep in a cool, ventilated, dry place and the temperature is blew 27oC. It belongs to non-dangerous goods . Meet the standard: JC/T 885-2001 Q/JY4-2006 No.:ItemThe StandardTest ResultIndividual Assessment1AppearanceNon-dispersed particles,crust and agglomerations. Non-liquid precipitation.Pass the standardPassable2Droop Degree(mm) Uprightness≤30PassableLevel No distortionNo distortionPassable3Extrusion ability, (s)≤101.1Passable4Tack Free Time, (h)≤30.6Passable5Tensile modulus (Mpa)23 0.4 or0.60.8Passable-20/Passable6Definite ElongationNo breakNo breakPassable