XK-QD1 Type SPS-Steuerung Pneumatische Teaching experim

1 Overview XK-QD1 type PLC-control pneumatic teaching equipment table is mainly composed of experiment table, pneumatic componentg, air source, tool accessories, etc. 1) Experiment table workbench This workbench table-board of this set adopts common used “T” type aluminum profile in industrial control so that the pneumatic components can be conveniently installed and positioned. We also provide: 1 stretch metal cassette 2 “T” type dedicated nut two-way installation way, so that can conveniently provide to users standard component/nonstandard component extension experiment. The rack of this set is entirely welded steel construction. Its surface is spraying plastic. It is sturdy and durable. Dimensions: Height 1800mm×Length 1500mm×Width 630mm 2) Electric control component The Electric control component is module structure. On the right side of the set there designs guide rails who can install seven control modules. It can be easily combined and extended so that it can be easily repaired and maintained. Standard configuration contains: power module, PLC module, input module, output module, relay module, extension module and air-capacitor module. (Later on) Extension or exchange modules: extension input/output module of PLC, AD/DA module, control instrument module, sensor module, etc. Power supply: input: AC 220V 50Hz Output: DC 24V/2A PLC (programmable logic controller): Mitsubishi FX2N-16MR type mainframe (relay output mode) Input module: connect with PLC by the cable (9 pin 232 interface). After connection it can supply for PLC 8 channel master input signal (of these, 2 channel are normal closed signal). Through signal jack, it can supply automatic control signal to PLC. (Like position signal of position switch) Output module: connect with PLC by the cable (9 pin 232 interface). By output interface jack, it can control solenoid valve on/off. Relay control module: after connecting with power module, it can control master signal and supply automatic control signal for automatic control. By output interface jack, it can control solenoid valve on/off. 3) Pneumatic components