Vakuum-Kunststoffkleber

Technical parameter Ingredient: PUR dispersion Solid content: 51±2% Toxicity : NON Appearance: Milky white liquid Brinell viscosity : 350 – 800CPS PH value : 6 9 Usage method Completely mix 3-5 percent of curing agent with LK-160 in special requirement,then coat the glue by manual or rolling machine. This mixed glue must use up within 4 hours, otherwise throw it away. Glue-coating temperature: Above 10°C Materials moisture : 8 - 12% Glue-coating quantity : 50 - 150g/m2 Drying : 30 – 60mins Air pressure time :80-120seconds Air pressure temperature : 80-110°C Pressure : 3 - 4P Activation temperature : 55-65°C Cleanness Whenever possible, use the warm water to clean up the glue before it will dry. If the adhesive attached on the facilities, and clean it by hot water or knife. If the glue splits out, then spread the washing powder containing borax on the surface of exceeded glue. Half an hour later, the solidified glue is easily cleaned up from the floor. Notice In order to reduce the glue to stimulate human body, the worker should wear safety glasses, working clothes, and use soap and warm water to wash the position, which has touched the glue.