unter Kfz-Einbausatz geführt

led under car kit: Light Source: Super bright plug LED can be controlled to change different color manually by remote control (one controller with one remote may control one strip or two strips or four strips) 1. Lift the car with the elevator platform 2. Find the place you want to install,usually 4 LED strips is enough around the car.Cleaning up where to insta 3. Drill a hole at the chassis along with near to location of Strip to be installed at 20-25CM intervals ,if Led Strips cann’t be tied with Cable ties at the location where to install Strips. 4. Fix the Strips on the chassis with cable ties after holes drilled. 5. The power wire access can be 12V Car power supply when installing.It can be controlled directly with our wireless remote controller tobe light on and off. 6. Lighting Test 7. Installation completed Control modes: (1) button ON and OFF (2) mode button 1.RGB full cycle 30 seconds 2.RGB full cycle 15 seconds 3. RGB full cycle 7seconds 4.Red ON 5.Green ON 6.Blue ON 7.Red/Green ON 8.Green/Blue ON 9.Blue/Red ON 10.Blue/Green ON 11.Red/Green/Blue ON