überholen Auto für Kabel Brücke

The maintenance and repairment of all kinds of cable-stayed bridges upper-anchor and the main bridge can be realized through model Q-SCD200/DL30A product. In this equipment, lift system should be installed in outside or inside of the cable-stayed bridge, which can be the work platform to maintain the main bridge and upper-anchor and adjusts the main bridge and upper-anchor. The work platform can up, down or stop to any point of the main bridge so that the staff can work conveniently. The following is this products parameters: ItemsUnitsParametersRated loadkg2000 or 300Operation speedm/min9.3Detection of cables diameter(according to you situation)Tilt angle of cable-stayeddegree20 -- 80Distance of remote controlm120Effective driveG115(It can work 100 hours)Temperature of applicable environment -20 --- +40Wind speedm/s≤10.8(6 wind)Relative humidity≤90%(25)Electrical powerKW2×2.2Braking torqueN.M2×15Rated upgrading powerKN2×7.85Rated voltageVAC380±5%Weight of maintenance equipmentkg470Weight of the whole machinekg1000The minimum braking rally to tracing wire-ropeKN2×68.5Size of frame(length×width×height)mm2000×1000×1720 Note: this equipment has no standard provision. We will design the product according to your situation. The distance of the remote control, the tilt angle of the cable, the diameter of the cable, applicable environment, and so on, all of above will decide the size of the product you ordered. So, before ordering the product, please communicate with us so that we can provide the most accurate size product to you.