Small-size Driving Type Thermoplastic (Convex)Road Marking MachineEngine:Honda/Robin CE.ISO9001 Cold solvent/water-based/two-component paint spray guns flexibly This is a type of screeding general road marking machine, compact and small, flexible to operate. Under the premise of sufficient melted material, it also has relatively high construction efficiency. The type I is for flat line, and the type II is for flat line and convex line. 1.Dngine: Japanese Honda 20HP air-cooled electrical starting single-cylinder gasoline engine. The fuel tank’s Capacity is 40L. 2. Driving system: Imported oil pressurized continuously variable speed transmission system directions Driving speed: 0-22km/h, maximum climbing capacity: 15°. 3. Heating mode: Propane infrared heating source, saving the gas 30% than the traditional heating way. . 4. Marking mode: Equipped with hydraulic screeding marking shoe; structure board is made of imported special steel sheet with high-temperature resistance (2000°C), oxidation resistance and deformation resistance. 5. Glass bead spraying system: 55L single pressure type glass bead tanks with visible window. 6. Electronic control: Set up various standard linetype control mode to realize micro-electronic intelligent control; 7. Paint tank: Cool-rolled oxidation-resisting steel paint tank, in whose interlayer the high-tech thermal insulation material is filled. Paint Capacity:150L. 8. Air compressor: 0.6 m3/min piston type air compressor. Option for a pre-heater trailer according to the needs of the users to make the long transportation and paint melting convenient. Relative Equipments: DY-SPTC-II Self-Propelled Thermoplastic Convex Road Marking Machine DY-SPTC-III Self-Propelled Thermoplastic Convex Road Marking Machine DY-EHPT Exquisite Hand-Push Thermoplastic Road Marking Machine DY-TPR Thermoplastic Pedestrian Road Marking Machine DY-HPT Hand-Push Thermoplastic Road Marking Machine DY-HPA Hand-Push Airless Road Marking Machine DY-HPS Hand-Push Screeding Road marking Machine