Stahlflex-Netzkupplung

Material property of main parts:ItemParts NameMaterialStandard1Half coupling&steelflex grid coupling45#JB/T6397GB/T113522Enclosercast aluminium,15MnGB/T1173,GB/T15913serpentine spring60Si2Mn,50CrVAGB/T12224intermediate shaft45#GB/T7005boltMechanical property 8.8GB/T3098.1 The flange teeth surface of two half couplings which contact spring, the roughness (Ra) is 6.3um.Half coupling that the tolerance of axle hole is H7. Surface hardness (Re) of axle hole is 1.6um.After heat treatment, the hardness of Material of spring will be reach 43 47HRC. Any flaw, scar, impress, scuffing etc is not allowed.Half coupling, encloser, connecting flange, intermediate shaft and brake wheel etc are not allowed any flaw, shrinkage cavities, bubble cell, slag patch and other flaws which affect the strength. Excircle of brake wheel that the surface must be quenched and the hardness is no less than 35HRCBalance quality is no less than G16 during the dynamic balancing testing process of the coupling.Cleaning the coupling before assembly and apply antirust oil on junction surface. Non-junction surface must be painted or use other rust prevention treatment. Lubricating oil or grease lubricant must be used after assembly. Any leakage is not allowed during the operation of coupling. Replace with a new seal ring after 5000 operation hours. In normal conditions, the reliability of the coupling keeps stable within 10000 operation hours.