Solarregler / Power System Batterie-Ladegerät / cont

EPIP603 Solar Charge Controller for Solar System with Digital and symbol display,which is the third generation of controllers EPSOLAR characterized by high quality and reliability. Added new features and protection with the use of advanced technologies. The controller provides long battery life and better job of photovoltaic systems. The controller sets new standards for reliability and self-diagnosis of such devices. Distinctive feature of these controllers is the ability to store and transfer data through the RS-232. Data is stored in the last 30 days. STANDARD FEATURES: Version controllers: 30, 40, 50 or 60 amps autoselection 24/48 B, positive or negative common wire Determination of charge (State of charge - SOC) and the regulation of this parameter Installing the battery capacity, charge 4 modes (fast, leveling, supporting, PWM) Automatic load reconnection, manual load break switch Automatic selection of operating voltage depending on the connected battery (24/48 V) Temperature compensation Large LCD display: SOC as a fuel sensor, all system parameters in digital form, the mapping of the system in the form of symbols Full protection circuits, electronic fuse All parameters are set using the 4 buttons Options include automatic load - from dawn to dusk, from sunset plus a specified number of hours, manual transmission Built-in clock, time display on the display.ELECTRONIC PROTECTION: Short-circuiting the SB and the load Overloading of the SB and the load Incorrect polarity protection from discharge AB through Sat night Shutdown overvoltage The load is protected Surge Automatic recovery after operation of all defenses EPIP603 Solar Charge Controller Regulator Data Sheet Model ControllerEPIP603 30AEPIP603 40AEPIP603 50AEPIP603 60ANominal current from Sat30A40A50A60ANominal load current30A40A50A60ASystem voltage24/48VVoltage regulation28.8VFloat charging26.8VAlignment charge29.6VVoltage load disconnect22.2VVoltage reconnect load25.2VTemperature compensation (mV / K)-30mVOwn consumptionmode control: less than 10 mA, the display - less than 10 mA, total - less than 20 mAOperating temperature:-35 To +55Models equipped with 24/48V voltage offset end temperature sensors and computer programs for communication. RS-232 is not included. Note: All voltages are specified for the voltage of 24 V. For 48V to be multiplied by 2.