poe Einzel-Port-Ethernet-Netzteil

poe Features and Functions poe PROCET PT- PSE108-ARis a Single-port Ethernet Power Supply. It is suitable for indoor, can work between input voltage100VAC 280VAC. This power supply use category super type 5 cable to connect to other network termination equipments, suitable for 10/100/1000M network environment,effect distance of power supply is 100M. poe PROCET PT- PSE108-ARPOE has the following excellent performance: 1 The power circuit has the function of Input over or under voltage, output over voltage, output over-current short-circuit protection for each circuit.2 System reliability:MTBF>100k hours.3 Conducted interference(CE) and Radiated interference(RE),comply with EN55022, CLASS B standard.4 Lightning protection: Both positive and negative port of AC input can take 5KB, 8/20uS pulse current for 5 times, with interval of 1 minute. Power supply lightning protection circuit has the failure alarm function and safety protection devices like insurance tube etc.Operating Environment 1Temperature: -15°C +55°C 2Relative humidity: 5% 90%RH 3Places that are ventilate and cool, clean, no conductive dust, no corrosive gases. 4 Places without explosion hazard. Technical characteristics and parameters 1Input voltage: 100VAC 280VAC,47Hz 63Hz. 2Maximum power output: 24W. 3Output voltage regulation accuracy: -48VDC±2%. 4Load regulation: -48VDC±1%. 5Operating temperature range: -15°C +55°C. 6DC output voltage of broadband noise: 3.4kHz 150kHz≤50mv Dimensions and weight: Width: 45mm Length:82mm Height: 21mm Weight: <230g Remote power supply protection Range of output over-voltage protection: -52VDC -50VDCOver-current protection(Single circuit): 5000Ma 6500MaOver voltage protection: Input voltage over 290VAC 310VACOver voltage recovery point: Input voltage over 285VACUnder voltage protection: Input voltage under 80VAC 90VACUnder voltage recovery point: Input voltage under 90VACOver-temperature protection: >100°C Ethernet ports light instructions Red light POWER on:Show power working normally Green light ACTIVE on: show equipment supply power normally Installation and Commissioning 1.Connected output signal line respectively 2.Connect communicating & introducing line, signal wire, output lines tightly to avoid bad contacts and loose. 3. Insert the input power line into 110-220VAC introducing input socket.