Platz High Power LED Wall Washer (RGB)

12-LED Square Wall Washer adopt 1W high power Edison LED as light source. Its particular mini appearance desiging, can make the smaller rooms be colorful by changing light modes. The product can make single color and RGB color, single color is warm white, pure white, red, green, blue, yellow, available. RGB color is combined by red, green, blue high power LEDs. Among LEDs, adopt 5-pin signal wires to connect with each other. The console or DMX512 controler can output 1677216 kinds of colors, to realize the all units changing colors sychronically and continously, chasing, ect colorful effect. (lens and viewing angles) Waterproof rank is IP65, can be available indoor and outdoor both. Small and exquisite appearance designing is convenient to install, at the bottom , there is special fix hole for fixing firmly. Application: This 12W wall washers can be widely used in inner building, outer decoration, stage , council chamber,exhibition, architectural complex, civilzation plaza,and so on. Electronical and Optical Datas: Part No.WW4001Light SourceHigh Power 1W LEDInput voltageAC90V AC240V(50/60Hz)(R4,G4,B4)/W12Voltage220VViewing angle10° 120°(routine:50°)Maxinum PowerRGB:14Watts/W:16WattsLED LensSquare reflector,Round lensLED current350 mAProjection Distance20mSignal standardDMX512(RS485)Colors Quantity16777216Control modeDMX512 controler or consoleAnti-dust & waterproof rankIP65Environment Temperature-20°C +45°CWeight1.4kgNote: 1.When you use the product, make sure the suitable using environment. 2.Every wall washer will take 3 addresses, the No.1 wall washer address plus 3 is to be the next connected wall washer address. 3.When the wall washer works, if all the same group wall washers perform the same mode, should set all the wall washers the same address. 4.The square wall washer maxinum address cann’t exceed 510 5.There should be only one main controler in one group wall washers (work as main mode, controler, or console). 6.Many wall washers connect together, the connection should follow “Products Connection Layout”. 7.The distance between controler and controler or controler and signal amplifier, should not exceed 150meters, the maxinum distance between the controler or signal amplifier and the last piece light should not exceed 100meters.