Ölspender

oil dispenser ModelJTSA111C-201Flow rate range5 50L/minMaximum permissible error±0.3%Single volume0 9999.99literCumulative total0 999999.99literPower supply380V±15% 50HZMotor power1.5KWNoise level≤70dB(A)Ambient Temperature-40°C +100°C A,Product application 1,Suitable materials: Lubricating oil,engine oil, gear oil, antifreeze, coal tar, transformer oil, hydraulic oil, edible oil, mechanical oil, apply a wide range of fluids and viscous materials used in vehicle lubrication, commercial and industrial settings. 2,Materials viscosity range: 5-1500cst 3,Use of the environment: pumping from oil drum (the best) or pumping from the tank. 4,Applicable field: used to refuel lubricating oil to gearbox and driving axle in the production line of motorcycle or vehicle factory. field: used to refuel lubricating oil to gearbox and driving axle in the production line of motorcycle or vehicle factory, and refuel to Max. 180L oil drum. B,Product Name: Electronic Lubricant Dispenser C,Function: 1,Presetting and non-presetting function: the presetting function can also preset refuel times, e.g. if input refueling volume at first operation, it will refuel the same volume again in the following consecutive operation. 2,The cumulative total figure can be queried. 3,Remote control functions: when preset refuel times, it is not need to go back again to re-enter the volume. It will start to refuel the same volume by using remoter, which can be used in a radius of 20 meters of Dispenser. Refer to drawing. 4,Measure unit: volume. D,Control by Operator Panel on dispenser and Remoter, each one can be used along E,Products configuration: 1,Machines fixed on the ground 2,Hose length is 5 m. 3,Inlet pipe: junction part is corrugate pipe. 4,Nozzle: Automatic shutoff nozzle. Nozzle diameter has two size: 24mm or 32mm F,Please pay attention to oil tank and pipe requirements, if suction oil from tank. 1,If tank is above ground, outlet should be on the bottom of tank, pipe inner diameter is 40mm,a distance between tank and dispenser is less than 30M. 2,If tank is under ground, pipe inner diameter should be 40mm, a distance between tank and dispenser is less than 10M. If the distance is above 10M, it will affect refuel volume,the solution is to install the motor and pump within 2 meters scope of dispenser, then the dispenser can suction oil even the tank is 200 meters away. G, Options: 1,Tank gauge system: it consists of probe and controller. It can gauge real-time oil level and give alarm; print inventory, delivery and shift report. 2,Dispenser management system: to monitor and control every dispenser, monitor dispensers working condition. It can print daily/monthly working report, and compatible to tank gauge system. H,To customers: when you decide model, please inform us: 1. injunction port diameter. 2. length of refueling hose. 3. refuel volume. 4. material name and viscosity.