Low ESP Concealed Impeller-Coil Unit

ModelFC-07L1WAA-200LFC-09L1WAA-300LFC-12L1WAA-400LFC-15L1WAB-500LFC-18L1WAB-600LFC-24L1WAC-800LFC-30L1WAD-1000LFC-36L1WAE-1200LFC-42L1WAF-1400LElectric DataPower Supply220V 240V/50H/1 PHMax InputW75115115150225225308308450Max. Current(1)A0.30.50.50.71.01.01.41.42.0Physical DataCoilFin heightinch668688888mm152152203152203203203203203Fin lengthinch242424343444515865mm6106106108648641118129514731651Face areaft21.001.001.331.421.892.442.833.223.61m20.090.090.120.130.180.230.260.300.34Max. working Pre.2Mpa---20 kgf/cm2FanTypeDouble inlet forward curive centrifugal direct driveCode/Qty6"×8"×1nos.6"×8"×2nos.6"×8"×4nos.6"×8"×4nos.6"×8"×4nos.MotorTypePermeanent split capacitor multi-speedPermeanent split capacitor multi-speedPermeanent split capacitor multi-speedQty111111222Output (2)W25404060808060+6060+6080+80External Static PressurePaNominal 30 Pa/ Max. 50PaNominal 30 Pa/ Max. 50PaNominal 30 Pa/ Max. 50PaNoise Level(3) (Low Speed)LP_dB(A)<36<36<36<38<40<40<45<47<48Coil Circuits(4)1 Row3343444442 Rows3343444443 Rows3343446664 Rows334344888Chilled Water Connnection1/2/3 Rows1/2"FPT --3/4" MPT4 Rows1/2"FPT--3/4" MPT3/4"FPT--1" MPTDrain PipeG3/4"Net Dimension(W×D×H)mm975×530×2601215×530×2601470×530×2601650×530×2601830×530×2602000×530×260Shipping Dimension(W×D×H)mm995×545×2701235×545×2701490×545×2701670×545×2701850×545×2702020×545×270Net weight2 rowskg10.311.212.214.515.516.818.228.932.23 rowskg11.312.614.016.618.019.822.034.238.74 rowskg12.514.215.218.520.021.824.037.645.3Shipping Weight2 rowskg12.313.214.217.518.519.821.732.436.23 rowskg13.314.616.019.621.022.825.537.744.74 rowskg14.516.217.221.523.024.827.541.149.3Optional FWS Under Power Supply: 208 230V/60Hz/1Ph, 115/60Hz/1Ph, 100 110V/50Hz/60Hz/1Ph. Notes : (1) The currents are under the 220V voltages. (2) The motor output may be revised according to the actual external static pressure drop. (3) Test point is at 1 meters leaving the unit air supply outlet in the ARI standard acoustic room. (4)Coil circuits means water circuits inside our standard units. This can be adjusted according to the requirements of the application.