Lexia 3 S. 2000

Lexia 3 pp 2000 Description:PP 2000 diagnostic scanner for comprehensive Citroenl and for Peugeotl carsdiagnostic. You can do all as a authorized dealer does.This diagnosticssoftware allows you to perform complete diagnostics of all from 1995 untillpresent models. Diagnostics is performed via OBD-II connector (which islocated near steering wheel) or via manufacturer-specific connector (onlyolder cars, pre-2001). Supported functions Unlike other universal car scanner tools which only read fault codes, thissoftware performs nearly ALL the functions like the original dealer diagnostictool. Our diagnostic interface contains K-Line multiplexor, CAN-BUSinterfaces and SAE J1850 bus (both PWM and VPW).The following diagnostic functions are supported: Read identification Displays complete identification of control unit, e.g. part number,software/hardware version, manufacturer, etc... Read fault codes Displays all stored and pending fault codes with complete description (e.g."Rail pressure - too low pressure"). Program supports report printing or copy to clipboard. Clear fault codes This function clears all stored fault codes and other diagnostic information. Auto-scan (complete car scan/test) Detects all ECUs (electronic control units) installed in car and reads alldiagnostic fault codes. Measured Values Program displays live Data like Engine Speed, Battery voltage, OxygenSensor, Coolant Temperature, etc. Values can be displayed in graph, 9values at once, or full listing (all measured values). Logging to file is alsosupported, which allows offline analysis. Actuator test Actuator test activates particular actuator (e.g. turn on fuel pump,lock/unlock wheel, lock/unlock doors, cut off fuel, etc..) Programming functions/Adaptation This feature is of great importance in all vehicles because systems likeEngine control units, Immobilizers, Airbags, Alarms, Body Control Units, andsome others, require you to perform reset or programming procedures aftercar repair is done, or even configuration after replacing broken Control Unit. Hardware and software requirements Software requires at least Intel Celeron/Pentium III 400 MHz, 128 MB RAM,50MB free HDD space and USB 1.1 port (USB 2.0 recommended) andMicrosoft Windows 98 SR2/2000/XP with the latest service pack installed. If customer requires, we can prepare ready to work PC.Set includes:Main unit OBD-2 cable USB cable Software CD