LED-Solarstraßenbolzen

led solar road stud is widely used around the world.Key features:Square design creates good appearance while relieving the impaction from traffic load so as to be durableCombined size complying with the size of round post and saponaceous appearance, it can be installed at the top of round post at the cross, and make the cross clearer at nightTwo reinforced veins are designed inside to strengthen compression resistanceSolar panel, electronics and optics are fitted inside waterproof and unbreakableAccording to requirement the number of LED can be single light, double lights and three lights in one side, as well single light, double lights and three lights in both sidesTwo screw holes are designed on both sides so as to be fitted steadily with screws in road or round postEpoxy glue is filled in the shell. Easy, simple and steady to install like a standard road stud with two screws or glue, both in road and in round postSuitable for edge line of roadstrong resistance.shockresistance: can resistent the impact from automotive tires.high and low temperature endurable: temperature range -40°c to +60°c.anti-corrosion: under go water, oil, chemical and other corrosive substances.beautiful: bright color, reasonable style and diamond-like crystal clear lighting, very enjoyable, lighting roads and beautify the city.Under normal day light charge, can work for four days, up to 12 consecutive rainy days Installation Procedure: 1. Check if the solar stud charge and discharge in normal way; 2. Identify the place for installation and clean it; 3. Clean the bottom of the solar stud and glue it onto the installation place; 4. Steady it with two screws. Ok, all is over, but the solar stud will be not workable until 6—8 hours later after installation.