Kupfer-Edelstahl-Heizung Induction Heating P

Copper stainless steel heating Induction Heating Power Supply AtecD series of high-frequency induction heating power supply for the copper stainless steel heating: Copper, brass or stainless steel workpiece heating, required that induction heating power output higher frequency, and output high current density in the inductor, to achieve the purpose of heating the workpiece. AtecD series of high-frequency induction heating power supply, through the specific impedance matching, can be used heating copper, brass or stainless steel, complete welding, heat treating processes. M-Series High Frequency up to 100KHz, can be used to heat small work piece. All air cooled structure, high system efficiency, the temperature of the workpiece rises fast, the temperature of the other place of the workpiece rise a little, heat-affected small. IGBT inverter, efficiency and power factor are high. System failure rate is low, the device has no water system failure. Built-in temperature PID procedures, can realize constant temperature heating.A variety of control methods and a rich interface, easy to implement automatic control. Precise control of the DSP, the frequency of automatic tracking, ensure that devices work in the best resonant state; and if the grid voltage fluctuated, the output power will remain unchanged. Fully functional and reliable protection limit, short circuit in the sensor, workpiece short-circuit, overload operation, abnormal fluctuations of the grid, the equipment will not be damaged. Output transformer isolation, the sensor voltage is low, and can be single-grounded. Air-cooled transformer design life of 10 years, no brass jams. No polarity filter capacitor design life of 10 years (electrolytic capacitors less than 5 years). The parameter setting functions online.