Hydraulische Tire Formen und Härten Press B-Typ

This Curing Press is appliable for curing TBR,LTR and bias tyres with Nitrogen or steam as curing medium. This Curing Press is a Hydraulic type, the beam moves vertically and horizontally for tyre loading and unloading. The center mechanism is BOM type and the curing mould is heated by Platen.This Curing Press is equipped with Dual-Column Vertical Chuck and Swing type Unloading Device for tyre loading and unloading. As per customer's request, Auto-Adjusting Device, SMO Drive Device, PCI and Green Tyre Holder are available. Curing Piple can also be made into order. This Curing Press uses PLC for real-time control, and industrial PC for Human-Machine Operation Interface.All parameters can be re-set during Curing Cycle, and real-time data collection/preservation,alarming,as well as data back dating can also be realized through this system. With ethernet interface,Curing Press group-management is available. One Oil Hydraulic Station can be fitted on to drive and control one or up to five Curing Presses. Proportional Electric-Hydraulic Control Technology is adopted for Mould Open/Close Speed adjustment. Brief Technical Parameters: 1Type of Cured TireTBR and bias tyres 2Heating TypePlaten 3Number of Mould24Type of Center MechanismBOM5I.D. of Mould Shield1140mm6Max. Mould closing force1360kN X 2 7Height of Mould190-430mm8Max Mould Weight kgs 9Diameter of Bead12"-18" 10Max. Height of Green Tire370mm11Max. OD of Cured TireTwo-piece Mold810mmSegmental Mold740mm12Max.Section Width of Cured Tire mm13Designed Mould Open/Close time s14Max Load of VCL kgs15Max External Pressure1.4Mpa?16Max.Internal Pressure2.8Mpa?17Hydraulic Water Pressure2.1-2.5Mpa?18Compressed Air Pressure0.7Mpa?19Control Air Pressure0.35Mpa? * Our Curing Press range is 42", 45", 48", 51", 55", 63.5", 65.5".