Hallo-Temp Polyesterspachtel

2300 product description (Anti- high temperature putty) Application&characteristic It is mainly used for the filling and leveling up as well as decoration of the deficiencies such as sand holes, shrink holes and cracks on the surface of polyester putty before closing the undercoat in the painting dressing of cars, so as to strengthen the flatness and smoothness of the surface of polyester putty. Good applying, outstanding function of temperature variation resistance, excellent adhesive force and sanding property. Especially applicable to high requirement of temperature of surface filling. Such as automotive hood, produce high-temperature mechanical surface application. Scope of construction: It can be used in iron panel, steel plate, stainless steel plate, aluminum panel and on any painted metallic surface. Main performance indexes: Itemindexes Test method Flexibility(mm)50 GB/T1748Impact strength(kg.cm)≥20GB/T1732Thermal resistance1h baking under 180+5 No bubble, no crackGB/T1735AdhesionFirst classBending methodTemperature variation resistance(3cycles)No bubble, no crackEye testSanding propertyEasy sanding,extraction powder is fastHand feel P.S:Temperature variation resistance -401h1h(at ambient temperature)1201h is a cycle. Application: 1. Remove the oil, rust, original paint film and water etc from surface completely, keep the painted surface clean&dry before scraping. 2. The putty may cause uneven in the process of storage, must use clean ruler stir well before the use. 3The putty and hardener should be mixed completely to achieve the uniformity of color (general ratio is 100:2 by weight), and apply the mixture within potlife(3-8min), or it will gel. 4Apply the mixtured putty to the processed surface of primer or cold-reduced sheet, in case of scraping of thick coat, it is preferable to apply in thin coats for several times till reaching the objective thickness. (Suggested maximum thickness is no more than 2mm). 5Wet milling or dry milling should be made after hardened thoroughly. The best wet milling time is 0.5-1h after applying putty, and the best dry milling time is about 2h after applying putty(The temperature is 25, humidity is less than 40%). Ensure the putty has been completely dry when painting , lest drop off or bubbles. Notices: 1When there is air bubble while applying, fully scrape to evenness with spatula to ensure good adhesion. 2The putty mixed with hardeners should not be returned to the original container, container which is opened must be carefully resealed, lest volatilization &deterioration of solvent. Do not mix lacquer thinner to putty. 3When there is low temperature or high relative humidity, curing time of coating will be extended somewhat. The corresponding adjustment can be made to the consistency and gel time of putty according to per customers request. 4Our product matches with various primers, but not in phenolic primers and alkyd primers, lest drop off or bubbles. Ensure the primer has been thoroughly dry when applying putty, or cause drop off.() 5Above 160 baking must gel 8-24h at ambient temperature after it has been thoroughly dry. 6. To get a higher heat-resistance, it can be baked at 120° c - 150 ° c for 30 minutes after drying then bake at 200 ° c after it cool to the room temperature, so the better adhesion, and the highest heat resistance can up to 230° c - 260° c. 7. The product should not apply in galvanized sheet directly. 8.The shelf life can be up to 12 months at the cool place (under 25).