Gürtel Entwässerung Umrüster

Technology characteristics Series DYQ tectonic belt filter press compact, innovative design, operation and management to facilitate the low rate of filter cake moisture content, the effect well. It compared with the same type of equipment has the following characteristics: 1, the first paragraph of gravity for tilt-type dehydration, sludge from the filter surface up to 300mm, so that gravity dehydration of sludge in the first paragraph h increase in hydrostatic, high-capacity gravity dehydration. 2, gravity dehydration long paragraph, the first paragraph with the second length of 5m gravity dehydration many, so that the sludge in the press before the full thickening. At the same time, water gravity inversion, etc., also set up special institutions, the "wedge" shape, "S"-shaped, such as the role of press, so that the sludge cake moisture content was the lowest. 3, the first roller dehydration using "T" type vent tank to squeeze a lot of water quickly after the discharge, thereby enhancing the dewatering effect. 4, filter and so on with deviation with automatic transfer device or partial artificial screw, filter and filter belt tension with the freedom to adjust the speed, convenience of operation and management. 5, low noise, no vibration. Working Principle By the concentration of sludge flocculant dosage, fully mixed in the mixer after the inflow of gravity dehydration reaction paragraph, when the sludge dewatering by gravity inversion section of agencies turned to sludge dewatering and loss of mobility, and then by the "wedge "type," S "-type press, in the" S "-type press paragraph, sludge belt filter caught between two floors, with a number of different caliber repeatedly pressing roller, so that filter cake further dehydration, the final will filter through the scraper scrape down cake, and the upper and lower filter with automatic flushing and then continue to use it.