Full-Drehkreuz, volle Höhe Drehkreuz

The DBFT-S120 is designed to provide unsupervised access control into, and out of, high security facilities. The impenetrable construction virtually eliminates any unauthorized entry to restricted areas The rigid welded stainless steel construction of the full height rotor turnstiles offers advanced reliability and vandal resistance, and guarantees many years of the turnstile trouble-free operation even in unfavourable environments. The rotor is manufactured in stainless steel and is available in either four section (90 degree) or three section (120 degree) versions. Dimension:1680x1500x2310mm Protection level: IP55 CONTROLS AND INTERFACE Operating temper range: Designed for secure operation with asthetics in mind Corrosion protected S/S frame Featuring fully welded exterior components Minimal exposed hardware Heavy gauge materials meeting ASTM standards DBFT-S120 consists of rotor assembly, shield assembly, barrier section, mechanism housing, and ceiling plate.Heavy -duty high precision mechanism Nickel Plated for high corrosion resistance. Mechanism designed not to lock at 45º. Top rubber shock absorber limits shock load damage to mechanism. Mains Power Supply can be installed from the bottom or from the top of the unit. Modular assembly provides for moving Turnstiles in through confined routes for final installation. Easy access to electronic control modulesModular plug-in electronics provides for easy and quick repairs.Programmable electronic selections i.e. Auto relock after a predetermined time if no action is detected.Power failure options - unit remians locked or unlocked during power fail mode.On board counter unit standard - retrievable by Hand Held module.Key switch override standard on all units.Remote mounting of control electronics possible.Customized sizes and finishes available on request.All framework epoxy powder coated in Hammer Tone Grey, but any other Textured RAL coulours are available on request.Mounting base size 1200W x 1700L x 130mm deep.Concrete requirement: 20Mpa Minimum.Minimum ceiling height requirement 2600mm from the floor.Gate walk through opening 500mm.Physical size: 1420W x 2060h mm. Mass:±200kg.304 Stainless steelHot dipped galvanized carbon steelPowder coating to colour of choice (according to RAL) is available.Passageway width : 650mm Stainless steel thickness : 1.0 1.5mm Color anodizing (black, light, medium or dark statuary) Pulse relay Time-out relay Heel protectors Color anodizing (black, light, medium or dark statuary) Available in Fail-safe(open on power failure) or Fail-lock(Lock on power failure modes) Additional options on request The use of the electro-magnetic drive and mechanism ensure smooth and quiet operation as well as dynamic braking and crossbars positioning.Release of the crossbars will be cancelled if no one passes through by pre-adjustable period. Stainless steel : all external fabricated materials are composed of #304 stainless steel Powder coated : the powder is electro- statically applied, then baked to assure proper curing and adhesion. the color of choice(according to RAL) is available Galvanized : all exterior tubing and sheet metal surfaces receive a coating of hot molten zinc(black,light,medium,dark statuary) Passageway width : 650mm Throughout : 30 person/min