Epoxy Patrone

JG602Heavy duty-Hi load Adhesive for Chemical AnchoringDescriptionJG602 is pure Epoxy based, Heavy duty-Hi load Adhesive for chemical anchoring in cartridge packaging.Fields of ApplicationJG602 is used in;• Chemical anchoring to concrete and brick walls,• Repair and insulating of wide cracks,• Bonding of various types of construction materials such as steel, concrete, brick to each other,• Anchoring the rods and deformed bars to the concrete, stone or brick.Benefits• Rapid curing.• Can be applied on damp surfaces on concrete.• Pasty consistency, easy to apply and non-sag properties in over-head applications.• Resists to chemicals.Technical Dataproduct :JG602variant : 360ml 5:1 dual action side by side cartridge designation : heavy duty - hi load material : pure epoxy ,styrene free finish : gray on mixingApplication ProcedurePreparation of Anchor HolesAnchor holes should be drilled 6mm wide than anchor bar’s diameter and drilled in designed depth. The holes should be cleaned by using a steel brush and air guns.Anchor bars should be cleaned from rust, dust and grease before anchoring.MixingJG602 is packaged in ready to use cartridges. Fix the mixer nozzle to the front end of the resin cartridge. Fit the resin cartridge into the special dispenser gun and apply the correct number of trigger pulls until the colour of the resin comes out from the nozzle, changes.Application MethodAfter removing the first resin came out from the nozzle apply the correct number of trigger pulls starting at the far side of the drilled hole. Insert the rebar or threaded rod into the hole. Install the anchor bar into the hole slowly by screwing and do not drive the bars. For threaded rods, apply the correct tightening torque only after the curing time specified for the resin. Watchpoints • Do not use the resin first coming out from the nozzle.• During the application the substrate and environment temperature should be between 5-35oC. • Do not apply the product on to the wet surfaces.• Resinous materials’ pot life and curing times vary depending on the relative humidity, substrate and environment temperature. Reaction gets slow in low temperatures and it causes to extension on pot life and working time. On the other hand high temperatures speed up the reaction, which results to short pot life and working time. For full curing of material, both the substrate and environment temperature shouldn’t be under allowed application temperature. CleaningAfter the application all tools should be cleaned with a proper detergent or solvent such as thinner. YUANDA® JG360 can be cleaned with only mechanical abrasion after hardening. Packaging 360 ml cartridge,40 Pcs/carton Storage Store in original container in cool (+5oC - +25oC) and dry indoor conditions. Shelf life 12 months under proper storage conditions after production date. Health and Safety It is dangerous to get close to the store areas with fire. The store must be well ventilated.Work clothes, protective gloves, glasses and mask defined in Labour Laws must be used during theapplication. Avoid from material to contact with skin and eyes. In case of contacting wash your skin with water and go to doctor immediately .Don’t bring any food and drink to the application area. Store the material away from the children.For further information Material Safety Data Sheets should be read. DisclaimerThis information and all further technical advice are based on our present knowledge and experience.YUANDA CO.LTD. is only responsible for product’s quality. The results, caused by wrong application and/or application methods and fields exception of technical advices on the application of the product in this technical data sheet, implies no liability or any other legal responsibility on YUANDA CO.,LTDCure ScheduleBase Material Temperature(°C)Gelling timeCuring time-10°C 0°C2 8hours96 150hours0°C +10°C1 2hours48 96hours+10°C +25°C30 50mins24 48hours+25°C +40°C20 30mins7 24hours>40°C12mins7 hours