Elektrischer Antrieb

Product introduction TKJ-40/60 electric actuator The output terminal of the electric actuator is a nut locking clip which can be directly installed on the output shaft of the air volume control valve; the mounting bracket used by the actuator can prevent horizontal movement of the actuator; its maximum intersection angle is 95° (mechanical limit); pressing the manual button on the shell of the actuator, the actuator can be manually adjusted; the turned position of the actuator can be displayed on the ruler of the actuator. 40Nm electric actuator is single type. If two or more actuators can be used simultaneously to drive a set of air valve or a subassembly air valve (also called parallel use), auxiliary electric actuator shall be chose for matching to avoid interference between the actuators. This actuator is applicable to three-gear cut-through air volume control valve. Main technical parameters ItemUnitTKJ-40/60Rated torque Nm40Running time sec60Power supply VAC220Frequency Hz507.5W 50/60HzPower consumption VA12Control signal 3 pointsRotation angle 0 90ºConstrain angle 5 85º(5º for each step)Position indicator 0 90°Rating values of the auxiliary switch 3(1.5)Amp 230VDelayed alarm 80S±10%Environmental temperature -25°c +70°c