D Serie Becherwerk / TD

Use I plant D-type vertical bucket elevator, from the sports section (hopper with traction tape), with the upper section of drive rollers, tension rollers with the lower part of section, intermediate casing, drive, backstop brakes etc. (see below) for up conveying powder, granular non-small-block mill cut or a half mill cut bulk materials, such as coal, sand, coke at the end, cement, water, ores. The machine is characterized by rapid centrifugal discharge: and for the traction rubber conveyor belt conveyor components therefore not suitable for large mill cut and dig large resistance of materials. Temperature of transported materials shall not exceed 60 degrees, the use of a heat-resistant rubber band to allow 150 degrees. The machine consists of four specifications: D160, D250, D350, D450. The machine's transmission capacity of 3.1 to 66 cubic meters / hour, 4 to 30 meters high. To meet different application requirements, the machine has a variety of production method and installation method. ItemHoist modelD160D250D350D450S PreparationQ PreparationS PreparationQ PreparationS PreparationQ PreparationS PreparationQ PreparationDelivery capacity(m3/ h)8.03.121.611.8422569.548Hopper capacity(L)1.10.653.22.67.87.01514.5Bucket pitch(mm)300300400400500500640640Weight belt with hopper(kg/m)4.728.810.29.412.112.121..321..3Convey adhesive tape: Width(mm)200300400500Convey adhesive tape :Layer4455Velocity hopper(m/s)1.01.251.251.25Transmission speed of the roller shaft(r/min)47.547.547.537.5Materials degree of maximum block(mm)25354555