CWDM SFP optische Modul

CWDM SFP optical moduleFeatures1.25Gbps operationDFB Laser CWDM Transmitter (1450/1470/1490 nm)Optical wavelengthrange: λc ± 7.5nmOptical Transmit DMI function10km reach on 9/125μm SMFWide dynamic PIN-PD receiverRx Port Return Lossis no less than30dBStandard serial ID information compatible with SFP MSASFP MSA package with duplex LC connectorLVTTL logic level RX LOSVery low EMI and excellent ESD protection+3.3V single power supplyOperating case temperature: -20 to +85°CApplicationsSwitch to Switch interfaceSwitched backplane applicationsRouter/Server interfacCWDMATMSONT/SDH/PDHFDDIFiber ChannelOther optical transmission systemsStandardCompatible with SFP MSACompatible with IEEE 802.3zCompatible with ANSI specifications for Fibre ChannelCompatible with FCC 47 CFR Part 15, Class BCompatible with FDA 21 CFR 1040.10 and 1040.11, Class ICompatible with Telcordia GR-468-CORERoHS complianceDescriptionThe SFP transceiver is high performance, cost effective module supporting data-rate of 1.25Gbps 10km transmission distance with SMF.The transceiver consists of two sections: The transmitter section incorporates a DFB laser. And the receiver section consists of a PIN photodiode integrated with a trans-impedance preamplifier (TIA). All modules satisfy class I laser safety requirements.The optical output can be disabled by a TTL logic high-level input of Tx Disable. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver.The standard serial ID information compatible with SFP MSA describes the transceiver’s capabilities, standard interfaces, manufacturer and other information. The host equipment can access this information via the 2-wire serial CMOS EEPROMprotocol. For further information, please refer to SFP Multi-Source Agreement (MSA).The SFP transceivers are compatible with RoHS.Regulatory ComplianceThe transceivers have been tested according to American and European product safety and electromagnetic compatibility regulations (See Table 1). For further information regarding regulatory certification, please refer to Howfflink regulatory specification and safety guidelines, or contact with Howfflink, Inc.EEPROM Information: The serial SFP module contains an EEPROM. It provides access to sophisticated identification information that describes the transceiver’s capabilities, standard interfaces, manufacturer. The serial interface uses the 2-wire serial CMOS EEPROM protocol defined for the ATMEL AT24C01A/02/04 family of components. When the serial protocol is activated, the host generates the serial clock signal (SCL MOD_DEF1).