Carpoly Water Based Transparent Holz-Farbe

Carpoly Carpoly-waterborne wood paintTransparent finish paint Product description: carpoly water-borne wood paint, a new generation product developed precisely by carpoly, are developed using "WAC-T" and "SAFE and SAVE" technology. With low volatile components (voc) and diverse decorative effects. The product display upgraded environment-friendly performance and it is your best choice for family decoration. Typical use: It is suitable for indoor decoration on the surface of clapboards, window, doors, chairs and tables. It is also applicable for straw and rattan surface as well as bamboo surfaces. Advantage: It is new environmentally friendly wood coatings with good hardness and high gloss. It is very convenient to paint. The film is fine and smooth, which can protect the coated film from damage. Specification: 5L 18L Pro code: HM2011 HM2003 HM2005 HM2007 HM2009 Finish: matte (30%-40%) semi-glossy (50%-60%), high glossy (70%-100%) Drying time:Surface dry: 15-30minutes (at 250and 50%relative humidity)Hard dry: 7-9hoursRecoat time: 2hours or aboveDry time will be strongly influenced by temperature and humidity factors.Storage: Keep in a cool and ventilated dry place. APPLICATION: 1,It’s suggested to use the fiber brush and dry abrasive paper specially designed for water-borne wood coating. 2,Water-borne primer sealer, primer and finish are painted orderly. 3,No stacking for new-coated wood. 4,No hurt or crash for the film until 7th day; prolong accordingly in awful dry environment. All depends on actual conditions. 5,Detailed technology can refer to the manual of “Guide specification for Carpoly water-borne wood coatings” and “attention to Carpoly water-borne wood coatings”. Thinning: thin the coating with 0 20% water per one container. Mix it enough Surface preparation 1,The moisture content of wood is limited to or below 14%. 2,Do not use it when the temperature is below 8oC or the relative humidity above 80%. 3,Keep the wood surface clean and dry before sanding, fat wood is not suggested. Application method Brushing or spraying is feasible. Brushing: 15-20m2/kg/layer; spraying: 5-20m2/kg/layer Typical painting system substrate systemInterior(all kinds)wood surface 1,carpoly water-borne wood sealer(1 coat) 2,carpoly water-borne wood primer(2 coat) 3,carpoly water-borne transparent varnish(3 coat) Spray recommendation: 1,Conventional spray: satisfactory through most equipment. 2,Airless spry: A typical set up for airless spray application would be a minimum working pressure on paint of 140KG/cm2(2000lb/sq in)with a spray tip size 0.43mm(17thou)and a spray tip angle 650. Attention: 1,Do not use matching products which are not produced by our corporation, and do not add other chemical elements. 2,Coating fault are easily emerged under the condition that the temperature is below than 50C. 3,Coating fault are easily emerged when the moisture content of fundamental material exceed 14%, and thorough desiccation should be preceded by the construction. 4,Faults of cracking and dropping-off are easily emerged if paint putty at the bottom coat is not completely dry or thoroughly burnished. 5,Construction is forbidden before good interlayer desiccation and normal burnishing process, to prevent the phenomenon of dropping –off or blushing. 6,The construction environment and instruments should be maintained clean, to prevent them from affecting the paint film effect. 7,Paint should be properly selected according to the selected sheet material and technology. Safety rules: 1,Keep the construction place ventilation, and observe the label precautions. 2,Keep the area clean and take care of your eyes and other sensitive parts of your body. Flush immediately and then get medical attention if emergencies. Caution: 1,The products should be stored in a cool, dry and well ventilated environment .Moreover, it must be placed away from high temperature, sparks or combustion sources, keep good ventilation in the storage place, in order to prevent the volatile compounds accumulate. 2,It is just for professional usage. Avoid children contacting. Please put the product away from food, beverages, and animal food. Warm tips: 1,In order to better guarantee the lawful right and interest of the consumers, it is not recommended to purchase products without full label identification. Beware of counterfeit. 2,The product is only to professionals, the details of product information refer to Use’s manual.