Bodenfarbe, Epoxy Bodenfarbe

JD1000 is a two-component solvent polyester floor paint. It can be applied in the cold and moist environment, especially in the wet and humid areas.Itsfinishis hardand wear-resistant. Large range of colors is available forchoice and it issuitable forthe floorof the light industrial workshop, office building, warehouse, etc. Application: 1.Surface preparation: Correct substrate preparation is critical for optimum performance. Surface should be sound, clean, dry and free from loose particles, oil, grease, and all other contaminants. 2.Primer: The main purpose of this primer coat is to seal the substrate completely and avoid air-bubbles in the body coat. According to the oil absorption of substrate, a second sealer coat may be required. The paint should be stirred evenly according to the mixing ratio, then apply directly. Using roller and waiting for 8 hours to recoat. Inspection standards for the primer: even film with certain brightness. 3.Undercoat: Mix JD-D10 with appropriate quartz sand according to the mixing ratio andthen apply.After it is dry, then recoat till the desired thickness. Waiting for 12 hours to continue the next step. Inspection standards for the undercoat: Non-sticky to hand, no softening, no nail print if scratch on the surface. 4.Putty: Grindingthe undercoat layer with 325# sand paper and remove the ash, and then mix JD-D10 with appropriatequartz powderand apply directly with drawknife. Waiting for 12 hours to continue the next step. Inspection standards for the putty: Non-sticky to hand, no softening, no nail print if scratch on the surface. 5.Finish:Grind the putty layer with sanding paper and then remove the ash; 2 layers of JD1000 are required, each layer must be applied in an interval of 12 hours. 6. Maintenance: 5-7 days. Don't use or washwith water and other chemicals.