Belt Conveyor ZEO-BC

The bulk material is loaded into the charging hopper of the conveyor belt and transported by the load-bearing conveyor mechanism, the belt, to the discharging area. The belt is supported by a roller carriage and set in motion by a driving device. Technical features: -Using the gear-motor drives class IE-2 produced by leading European manufacturers, that let to increase the specified run to 28000-30000 hours and to increase the energetic potential of the conveyor on 7-9% according to raise on 100% efficiency of gear-motor drive. -Compact dimension size of drive head of the conveyor due to binding of gear-motor drive on torque rod. -Using the fettle of high-wear part s of discharge box with constructive sheet steel Steel Pro or polyurethane Elasturan 6025. -Using of effective cleaning system, that precludes the spillage of dust, that sticks to the drag mechanism. -Increasing of working time of axles, cylinder hubs on 30-40%due to using of alloy steel with thermal treatment(volumetric hardening or carbonization). -Durability of the mechanism is provided due to the manufacturing of tension screw from Steel 45 GOST1050-8 and nut from the material БрОЗЦ7С5Н1 GOST 613-79. -Using of partial execution mode of transportation with low speeds(not more than 2.5m/s) and special calculated discharging system let to decrease the breakage of product on 1.5-2%. -Unification and changeability of the construction elements gives a possibility to minimize the work labor input during the performance restoration of the conveyor. -Increasing of belt durability due to the fluent swerving into channeled condition and return, and also exception of its fractures. -The possibility of construction the conveyor with dedusting cover or with cover from athmospherical condensation. -Using of build-in control devices of conveyor work(sensors of: backup, belt blastoff, belt speed, emergency stop with wire), block of belt reverse by slope angle more than 9 degrees, observance of work safety standards, safety instructions and also the ful integration into automated control of any grade grain mills. Technical specifications: -Capacity, (t/h) - 50, 100, 175, 250, 350, 500, 600, 1200, 1500, -Length, (m) - from 5 to 250 -Wattage, (kWt) - from 1,1 to 135 -Build - Closed (dust-proof of weather-poof shelter) or open