Automatische Reifendruckregelanlage

Automatic mobile air tyre inflation system E-0124-OPS-BAT Main Features: Rechargeable long life Battery **Completely mobile unit ** 174PSI/12bar/1200kPa Output pressure make the unit a fit for almost any size automotive service facility ** Inflate up to 6 tyres simultaneous could save 60% time than single tyre inflation ** Fully Automated, fully programmable, micro-processor controlled conversion system. Self-diagnostic features. Over Pressure Setting(OPS) Suit for: Car, Light Truck, Bus * Technical Data Summary Dimensions(Height*Width*Depth) 1400mm*500mm*600mm 55.1"*19.7"*23.6" Net Weight 26.7kg/58.7lbs Gross Weight 38kg/83.8lbs Packing size((Height*Width*Depth) 310mm*1420mm*510mm 12.2"*55.9"*20.1" Power Requirement 24Vdc(2 pcs 12Vdc internal batteries included) 100-240Vac 50 /60HZ charger included Power Consumption 23VA Operating Temperature Range -20/-4°F to 70 / 158°F Max Inlet Air Supply 174PSI / 12bar / 1200kPa Operating Range 5-174PSI/0.3-12bar/35-1200kPa Over Pressure Setting Range 0-29PSI/0-2.0bar/0-200kPa Accuracy ±1PSI/0.07bar/7kPa Resolution 1PSI/0.1bar/5kPa Units of Measurement PSI/bar/kPa Specifications: 1. Adjustable over pressure setting(OPS) 2. 6 air outlets allow simultaneous inflation of up to 6 tires 3. Auto-Start inflation 4. Automatic zero drift adjustment 5. Remain at last setting 6. Comprehensive diagnostics and error reporting 7. Audible and visual end of the cycle signal indicators 8. Large backlight LCD display 9. Vandal resistant mechanical switches 10. Suits Air compressor 11. 4 Nos.*8M/26ft standard hoses with single clip-on closed chuck 12. Long life design, up to 2 days of average usage before recharge Detail Description of OPS: Over Pressure Setting(OPS) When fitted,the bead of the new tyre must be seated on the wheel rim.This is done via inflating the tyre past the required pressure until the bead is in place.The pressure needs to then be reduced to the required pressure.Traditionally this is done manually and is therefore time consuming for the operator.The OPS function allows the operator to set the amount of over pressure between 0 and 2 bar/29psi/200kPa.The unit will then over inflate the tyre by the set amount before automatically deflating back to the final pressure required.