Anti-Rutsch-Bodenbeschichtungssystem

Name:SP-13 Anti-slip floor coating system Category:Floor Coating Detail: SP-13 is a two component industrial flooring system base on an advanced epoxy resin system with following properties: Excellent slip resistance. Excellent resistance to chemical attack. Strong adhesion. Application areas Food and beverage industries. Chemicalcosmetics and pharmaceutical industries. General production and packing areas. Commercial and industrial kitchens. Automotive facilities. Packing and colours SP-13 Part A: 15kg containers. SP-13 Part B: 15kg containers. SP-13 is available in a large range of colors. For available colors, please refer to colorchart. SP-13 Anti-slip floor coating system Product description SP-13 is a two component industrial flooring system based on an advanced epoxy resin system with following properties l Excellent slip resistance l Excellent resistance to chemical attack. l Strong adhesion SP-013 is available in a large range of colors. For available colors, please refer to color chart. Application areas l Food and beverage industries. l Chemicalcosmetics and pharmaceutical industries. l General production and packing areas. l Commercial and industrial kitchens. l Automotive facilities Performance date ITEM INDEX Touch dry ≤ 4 Drying time (hours): Hard dry ≤ 24 Solid by weigh ≥ 80 Shore D hardness ≥ 80 Bonding strength Mpa ≥ 2 Compressive strength Mpa 85 Tensile strength Mpa 10 Flexural strength Mpa 7 Abrasion resistance,750g/500r, weight loss, g ≤ 0.02 Anti-25% sodium hydroxide No change in 56 days. Anti-30%salt water No change in 56 days. Anti-petrol ,120 No change in 56 days The above figures are guide values and should not be use as a base. Application instructions Surface preparation l The compressive strength of the concrete substrate should not be less than 25N/mm2, the best application temperature is between 10--25.The air humidity must not be higher than 80%, the moisture content of the substrate shall not be higher than 8. l Correct substrate preparation is critical for optimum performance. Surfaces should be sound, clean, dry and free from loose particles, oil, grease, and all other contaminants l Remove oil, grease by scrubbing. Cement laitance, loose particles, pitch and other contaminants must be removed from the surface by sand-blasting. The alkalinity and porosity of the surface must also be considered when painting. l Fill surface cracks with Epoxy-Reinforced Solvent-Free repair mortar to achieve a level surface.